- SizeS
- Speed square7", tight fit
- Worn onBoth sides
- Built forTrim and indoor work
- ProfileThe slimmest in the range
- AvailabilityT2 Custom, made to order
What is the Packer designed for?
The first Packer was made at a customer's request for a small pouch that still had proper top pockets. It has a very small profile, but flat bottoms mean you can still get a hand inside and reach small items. Lukas has called it a candidate for the ultimate trim pouch.

How the Packer is built
- Flat-bottom main pouch with a small profile.
- Free-floating outer pockets, so the tools you use most stay easy to reach.
- Slightly narrower fastener pockets on the non-dominant side, still wide enough for loose screws.
Because the Packer is made to order in T2, the pockets are chosen when you order.
Does a 7" speed square fit the Packer?
Barely. It works if you use the square now and then, or carry a small trim square. A slim bit pocket above the slot makes access easier than a tape pocket would.
Packer vs Micro vs Slug
| Packer | Micro | Slug | |
|---|---|---|---|
| Size | S | S | M |
| Speed square | 7", tight | 4" micro | 7" |
| Pick it if | You want top pockets without the bulk | You want the shortest pouch | You want room to spare |
Who should choose the Packer?
Trim carpenters and installers who want the lowest profile that still organises tools on top.
FAQ
Is the Packer available ready-made?
No, it is T2 Custom and made to order.
How long does a Packer take?
Check the current T2 lead time on the Packer page.
Can it be customised?
Yes, pockets and colours are chosen when ordering.
Compare every pouch in the Pouch Guide, or configure a T2 Packer.